I am sure other people on this board can add more about draft vs. Hope this is some help on draft control vs. The 8N introduced position control, which is a small up/down handle under the seat on the right side-this was an improvement to the hydraulic. Used will have flat wear on the outer edge but will not affect the operation. The amount of tractive force is adjusted by moving the main lever forward increases the tractive force, or plowing depth. Ford Tractor 8N thru 4000 (before 1965) Draft Control Spring. In draft control, the unit adjusts the height of the hitch so the traction force remains constant. Since pure draft control can be oversensitive, mixed control is usually better. Kickout 2nd Position Remote - Factory Installed (Self-centering) 9000411P64 502. Draft and mixed control should only be used for tillage. The product type is All States Ag Parts Remote Valve Control Kit Ford. In this mode, three-point hitch maintains constant height depending only on the position of the main lever. General rule for using the mode selector in the 3 positions is this: Position control is the most widely used and should be used for all implements carried in three-point hitch above ground. In mixed control the function of the main lever is a combination of position and draft controls. In draft control the main lever actually selects the tractive force of tillage implements. In position control the main lever position is directly related to the height of the three-point hitch. Most tractors now have 3 positions on the 3 point lift control.
0 Comments
Leave a Reply. |